Pg. 14
7-5 .
Next, install the loose end of the belt and
feed it through the Belt Tensioner Housing, as
show in Fig. 7-D.
7-6 .
Now, move to one end of the frame and get
eye level with the under-side of the carriage, as it
sits on the tracks. Confirm that your Mount Clamps
line up with belt in the carriage by pushing your
carriage from one side of the frame to the other to
verify the alignment. If necessary, you can adjust
your Mount Clamps at the Frame Ends by sliding
them back or forth as shown in Fig. 7-E and 7-F.
7-7 .
To get perfect alignment, it may be necessary
to measure the distance from the belt to the front
track. Measure this distance on both sides of the
frame to make sure that they are equal. With the
belt properly aligned, tighten belt clamps down
completely on both ends of the frame.
Fig. 7-D
Fig. 7-E
Fig. 7-F
