Pg. 16
8-7 .
Thread the end of the belt up through the
Belt Tension Housing and out the top, as shown in
Fig. 8-F and Fig. 8-G.
8-8 .
Use the Knobs on the tensioner to pull the
belt through until relatively tight. There is no need
to overtighten the belt. When it is tight enough
use the knob to lock the belt in place.
Fig. 8-F
Fig. 8-G
8-9 .
Now, get eye level with the under-side of the
carriage, as it sits on the tracks. Confirm that your
Mount Clamps line up with the belt in the carriage.
This is easily accomplished by pushing your
carriage forward and back to verify the alignment.
If necessary, you may need to loosen the hex
nuts that attach your Belt Clamp /Belt Tensioner
Housing to your Bracket A/B and shift them left or
right. Once aligned, retighten these hex nuts.
Step 9: LCD and Cable Attachment
Parts Needed:
1- LCD USB Cable
1- Computer USB Cable
5- Zip Ties
5- Adhesive Tie Mounts
9-1 .
Place the remaining five (5) zip tie mounts on
the Jewel Sewing Machine, as shown with arrows
in Fig. 19-A.
9-2 .
Plug the LCD USB Cable into the LCD, as
show in Fig. 9-B and 9-C.
Fig. 9-B
Fig. 9-A
Fig. 9-C
