Pg. 17
9-3 .
Thread the LCD USB Cable down the
machine and attach it to the first two (2) zip
tie mounts using one (1) zip tie per mount, as
shown in Fig. 9-D.
NOTE:
Keep the zip ties loose enough that the
cord can move freely if needed.
9-4 .
Thread the LCD USB Cable down the
machine and attach it to the third zip tie mounts
using one (1) zip tie, as shown in Fig. 9-E.
9-5 .
Thread the LCD USB Cable underneath the
plastic casing, as shown in Fig 9-F, but do not
attach the cord to the zip tie mount yet.
9-6 .
Thread the LCD USB Cable back underneath
the plastic casing, leaving most of the slack to
the back of the machine. Next, plug the LCD
cord into the QuiltMotion Plate, as shown in Fig.
9-G.
9-7 .
Gather the slack form the LCD USB Cable
towards the back of the carriage but do not use
the zip tie yet.
9-8 .
While holding the LCD USB Cable move the
sewing machine all the way forward, shown in
Fig. 9-H and all the way back as shown in Fig.
9-I. Make sure that the cord is never pulled tight,
but that it is not so loose that it drags on the
table or interferes with the wheels. If you need
to add or remove slack do it and then perform
the same test again.
Fig. 9-F
Plastic
Casing
Fig. 9-E
Fig. 9-G
Fig. 9-I
Fig. 9-H
Fig. 9-D
