Pg. 25
Fig. 1-I
1-8 .
Turn your carriage onto its side and attach
the four (4) Motor Plate Brackets onto the
QuiltMotion plate using the four (4) M4 x 14mm
Phillips Head Screws. Insert the M4 x 14mm
Phillips Head Screws from the underneath side of
the carriage, as shown in Fig. 1-I, and 1-J.
Fig. 1-J
M4 x 14mm
Phillips Head Screw
Motor Plate
Brackets
top side
1-9 .
Next, you will install the Power Strip to the
Power Strip Bracket on your carriage as shown in
Fig. 1-K and 1-L. Turn your carriage upside down
again and return to the side of your carriage with
the Power Strip Brackets. Thread two (2) M6 x
10mm Hex Bolts through the slots of the Power
Strip and into the threaded holes of the Power
Strip Brackets. Tighten these completely.
Fig. 1-K
Fig. 1-L
M4 x 10mm
Hex Bolt
Power Strip
Power Strip
Brackets
