Pg. 32
7-5 .
Next, install the loose end of the belt and
feed it through the Belt Tensioner Housing, as
show in Fig. 7-D.
7-7 .
Now, move to one end of the frame and get
eye level with the under-side of the carriage, as it
sits on the tracks. Confirm that your Mount Clamps
line up with belt in the carriage. This is easily
accomplished by pushing your carriage to one
side of the frame and then to the other to verify
the alignment. If necessary, you can adjust your
Mount Clamps along the Frame End.
7-8 .
As a final check, measure how far the belt
is from the right, left, and center of the frame,
making sure the belt is parallel with the front track
all the way down, as show in Fig. 7-E, 7-F, and
7-G.
7-9 .
With the belt properly aligned, tighten the
M6 x 25mm Socket Button Head Cap Screws using
the provided 4mm Allen Wrench. Do this on both
ends of the frame.
Fig. 7-D
Fig. 7-E
Fig. 7-F
Fig. 7-G
