Pg. 47
Fig. 4-A
Fig. 4-B
4-1 .
Attach one (1) Belt Tensioner Housing to one
(1) Mounting Clamp using two (2) M6 x 12mm Hex
Head Bolts and two (2) M6 Hex Nuts, as shown in
Fig. 4-A.
4-2 .
Partially screw one (1) M6 x 25mm Socket
Button Head Screw into the Belt Tension Clamp, as
shown in Fig. 4-B.
Step 4: Mounting Clamp Assembly
Parts Needed:
2- Mounting Clamp
1- Belt Clamp Front
1- Belt Clamp Back
1- Belt Tensioner Housing
1- Short Belt
2- M6 x 12mm Hex Bolt
2- M6 x 24mm Hex Bolt
2- M6 x 25mm Socket Button Head Cap Screw
4- M6 Hex Nut
Fig. 4-C
Fig. 4-D
4-3 .
Attach one (1) Belt Clamp Front and one (1)
Belt Clamp Back to one (1) Mounting Clamp using
two (2) M6 x 24mm Hex Bolts and two (2) M6 Hex
Nuts, as shown in Fig. 4-C. Thread the bolts into
the nuts only until they grab the first thread, so
that the front and back clamps remain loose.
4-4 .
Partially screw one (1) M6 x 25mm Socket
Button Head Screw into the Belt Tension Clamp, as
shown in Fig. 4-D.
4-5 .
Slide the belt between the back and front
Belt Clamps, as show in Fig. 4-D (make careful
note of the direction of the belt teeth), and then
tighten the hex bolts.
Choose one end of the belt to attach to the Belt
Clamp Front and Back in the following steps.
Belt Tensioner
Housing
M6 x 12mm
Hex Bolt
M6 Hex Nut
Mounting
Clamp
M6 x 25mm
Socket Button
Head Cap Screw
M6 x 24mm
Hex Bolt
M6 Hex Nut
Mounting
Clamp
M6 x 25mm
Socket Button
Head Cap Screw
Long Belt
Belt Clamp Back
Belt
Clamp
Front
Belt Teeth
