Pg. 5
1-1 .
Turn your bottom carriage upside down and
make sure the back of the carriage (side with the
encoder) is facing towards you, as shown in
Fig. 1-A.
1-2 .
Place your QuiltMotion Motor Plate inside
your bottom carriage, noting the direction shown
in
Fig. 1-B. Make sure the power cord and cable go
underneath the bottom carriage.
Note:
You will need to slide the QuiltMotion Plate
all the way to the end of the carriage, then tilt it in
order to fit it in place in the bottom carriage (see
Fig. 1-C).
Step 1: QuiltMotion Plate Installation
Parts Needed:
1- QuiltMotion Plate
4- Motor Plate Brackets
2- Power Strip Brackets
2- Length Adaptors
1- Power Strip
7- M4 x 14mm Phillips Head Screw
2- M6 x 10mm Hex Bolt
1- Short Ribbon Cable
Fig. 1-B
Fig. 1-A
Fig. 1-C
Fig. 1-D
1-3 .
Next, you will install your two (2) Power
Strip Brackets (left and right), using two (2) M4 x
14mm Phillips Head Screws (see Fig. 1-D).
QuiltMotion
Plate
Bottom
Carriage
M4 x 14mm
Phillips Head Screw
Power Strip
Brackets
Power Cord
Additional Tools Needed:
Phillips Screw Driver
Adjustable Wrench
Level (to ensure the frame is level)
