Pg. 6
1-4 .
Attach the two (2) Power Strip Brackets to
the back of the QuiltMotion Plate by lining up
these brackets under the two slots of the motor
plate. Thread the two (2) M4 x 14mm Screws
down through the slots, and into the brackets
as shown in Fig. 1-E.
NOTE:
Before tightening
completely, be sure the plate is properly aligned
with the carriage.
1-5 .
There is a ribbon cable already installed with
one end plugged into the QuiltMotion plate as
shown in Fig. 1-F. Remove the cover of the Ribbon
Cable Box on the left Power Strip Bracket and plug
the other end of this cable into the Power Strip
Bracket as shown in Fig. 1-G.
1-6 .
Take the short ribbon cable that came in the
QuiltMotion package, plug one end of this cable
into encoder lever and the other end into the
Power Strip Bracket as shown in Fig. 1-H. Do not
replace the lid of the cable box in the Power Strip
Bracket yet, leave it off for now.
1-7 .
Next, on the opposite end of the carriage
install the two (2) Length Adaptors using two (2)
M4 x 14mm Screws, as shown in Fig. 1-I.
Attach the two (2) Length Adaptors to the
QuiltMotion Plate in the same manner as the
Power Strip Brackets in the previous step, by
threading the two (2) M4 x 14mm Screws through
the slots of the QuiltMotion Plate and Length
Adaptors.
Fig. 1-E
Fig. 1-F
Fig. 1-G
Fig. 1-I
Fig. 1-H
Length
Adaptor
Ribbon Cable
Box
