Application of
Assembly
3 - 195
Embroidery unit
Application o
f
Assembly
Application of
Assembly
5
Attachment of Timing belt and Y slider
1. Set the tension pulley assy to the X carriage unit, and tighten the two screws (screw, pan (S/P washer)
M4x8) temporarily. Hang the timing belt 40S2M862 on the tension pulley assy and driving pulley.
*Key point
• Fully tighten the screw after performing
"Adjustment of Belt tension (embroidery unit)"
.
2. Set the YT belt presser plate and Y slider to the timing belt 40S2M862 with the screw (screw, pan (S/P
washer) M4x8), then engage the gullet of Y slider with the slider part of X carriage unit.
*Key point
• Check that the tab of YT belt presser plate is inserted into the positioning hole of Y slider.
• Check that the gear teeth of Y slider is engaged with the gear teeth of timing belt 40S2M862.
Screw, Pan (S/P washer) M4X8
YT belt presser plate
Timing belt 40S2M862
Screw, pan
(S/P washer) M4x8
Driving pulley
Y slider
Screw, pan
(S/P washer) M4x8
YT belt
presser plate
Gullet
Slider part
Tab
Positioning hole
Screw, pan
(S/P washer) M4x8
Tension pulley assy
X carriage unit
Summary of Contents for BLDY
Page 2: ......