Basic of Assembly
2 - 49
Lower driving mechanism
Basic of Assembly
Basic of Assembly
2
Attachment of Lower shaft A assy
1. Set the two felts to the mounting position of arm bed.
2. Set the two lower shaft bushings to the two mounting positions of arm bed.
3. Attach the bushing presser A to the arm bed with the two screws (taptite, bind S M4x10).
4. Attach the bushing presser to the arm bed with the two screws (taptite, bind S M4x10).
5. Hang the timing belt on the pulley of lower shaft A assy.
6. Set the disk to the joint of lower shaft A assy.
7. Set the belt support lower to the tension pulley holder B assy, and tighten the two screws (screw, pan
(S/P washer) M3x6) temporarily.
*Key point
• Fully tighten the screw after performing
"Adjustment of Timing belt and belt support upper/lower clearance"
Taptite, Bind S M4X10
Screw, Pan (S/P washer) M3X6
Disk
Bushing presser A
Taptite, bind
S M4x10
Lower shaft A assy
Joint
Felt
Felt
Bushing presser
Taptite, bind S M4x10
Taptite, bind S M4x10
Bushing presser
Bushing presser A
Lower shaft A assy
Pulley
Screw, pan (S/P washer) M3x6
Belt support lower
Timing belt
Tension pulley
holder B assy
Lower shaft
bushing
Lower shaft
bushing
Summary of Contents for BLDY
Page 2: ......
