62
The pattern is usually placed at the center of the
embroidery frame. If you want to change where in the
fabric the pattern will be embroidered, you can check the
position before starting embroidering.
Checking the needle drop point with the
Embroidery Crosshair Positioning Laser
a
Make sure that the Embroidery Crosshair Positioning
Laser on/off key appears as
(ON).
The Embroidery Crosshair Positioning Laser indicates
the needle drop point.
• Each touch of the key turns the setting either on or off.
Adjusting the brightness of the Embroidery
Crosshair Positioning Laser
a
Touch
, and then touch
or
to display
page 4 of the settings screen.
b
Touch .
The Embroidery Crosshair Positioning Laser lights up,
and the brightness adjustment screen for the
Embroidery Crosshair Positioning Laser appears.
c
Touch
or
to adjust the brightness of the
Embroidery Crosshair Positioning Laser.
d
Touch
twice to return to the previous screen.
CHECKING THE POSITION OF THE
PATTERN
Embroidery Crosshair
Positioning Laser lights
ON.
Embroidery Crosshair
Positioning Laser lights
OFF.
Memo
• With certain types of embroidery frames, the
Embroidery Crosshair Positioning Laser function
cannot be used.
• If the surface of the fabric is too uneven or rough,
check and adjust the alignment of the Embroidery
Crosshair Positioning Laser and the needle drop
point before starting to embroider.
• When using the cap frame, check and adjust the
alignment of the Embroidery Crosshair Positioning
Laser and the needle drop point before starting to
embroider.
• You can align the embroidering position with the
Embroidery Crosshair Positioning Laser function.
(page 79)
