16
Figure 5
Figure 4
Installing Front Handles
CAUTION:
Unplug the Baby Lock Crown
Jewel III from the electrical outlet. All power
to the machine must be turned off when in-
stalling the front handles. Failure to do so can
result in damage to the machine.
IMPORTANT NOTE:
Care must be taken to
not pinch the ribbon cable under the handle
when it is tightened to the machine.
Locate the three longest Allen screws and the
5.0mm Allen wrench. To install the handles, tilt
the screen forward. Line up the three holes on top
of the handles with the pre-drilled holes on top of
the machine. Slide an Allen screw bolt into each
hole until it stops. Hand tighten, and then use the
5.0mm Allen wrench to securely fasten the handles
to the machine (
Figure 4
).
Once the Allen screws are in place, plug the ribbon
connector into the serial port on the left-hand side
of the machine (
Back-Side Diagram B, #22 on
page 14 and Figure 5
). Make sure the pins are
lined up so they are not damaged when the plug is
pushed in. Push the plug securely in place.
Summary of Contents for Crown Jewel III BLCJ18-3
Page 1: ...3 ...
