USING THE SENSOR PEN
50
Important Information about
Sensor Pen
The sensor pen emits the signal to the machine,
and then the sensor pen receiver receives the
signal to specify the position.
a
Sensor pen receiver
b
Signal is waved out from the sensor pen
Calibrating the Sensor Pen
Before using the sensor pen for the first time, be
sure to personalize it using “Sensor Function
Calibration” in the settings screen. Doing so
allows the machine to learn the position in which
you usually hold the pen.
Hold the sensor pen at a comfortable angle and
then calibrate the machine according to the
procedure below.
Be sure to keep the sensor pen at the same angle
while calibrating the first and second points.
a
Press .
→
The settings screen appears.
b
Press .
→
The General settings screen appears.
c
Display page 5 of the General settings
screen.
d
Press
after connecting the sensor
pen to the machine.
→
The Sensor Function Calibration screen appears.
*
If the message “OK to automatically lower the
presser foot?” appears on the LCD screen, press
to continue.
Memo
• The sensor pen can be used to touch on the
screen as a touch pen.
CAUTION
• Do not insert any object into the sensor pen
and the receiver, otherwise the machine may
be damaged.
IMPORTANT
• Do not put your hand, the fabric or any object
between the machine and the sensor pen,
otherwise the sensor pen receiver may not
receive the ultrasonic wave.
• Do not use the machine close to any other unit
which produces ultrasonic wave or a vibration
sound, otherwise interference may occur.
Summary of Contents for Destiny II
