17
a
Reference edge and reference point
b
First pattern (1)
c
Second pattern (2)
→
Message appears on screen and carriage will move
after pressing
.
m
Prepare two embroidery positioning stickers.
We will follow the on-screen instructions to
affix these two stickers to the fabric so that
the positioning marks can be detected by the
camera.
n
Affix the first embroidery positioning sticker
onto the fabric within the red lines by using
both hands to press down on each corner of
the sticker. Affix the sticker with the large
circle to the top as shown on machine. Then,
press .
→
The camera detects the first positioning sticker.
Note
• Using
and
in this screen, the position of
the second pattern can be changed. For details,
refer to “SLIDING THE POSITION OF THE
PATTERN TO BE CONNECTED” on page 29.
Note
• Use the positioning stickers included with this
product or purchase replacement stickers from your
Baby Lock retailer. If any other sticker is used, the
camera may not recognize it.
• The 182 mm × 257 mm (7 inches × 10 inches)
embroidery positioning sticker sheet with strong
adhesive is most appropriate for connecting
patterns. If any other positioning sticker is used, it
may peel off. If the sticker peels off, the patterns
cannot be connected.
b
a
c
Note
• Use new positioning stickers. If a sticker is reused, it
may easily peel off. If the sticker peels off during this
procedure, the patterns cannot be connected.
• Using fingers apply pressure to the corners of the
positioning sticker to firmly affix it to the fabric. If the
sticker is not firmly attached, the camera may
incorrectly detect the sticker.
• If any of the following messages appear, reattach
the positioning sticker in the correct position. Make
sure that the sticker is affixed with the large circle at
the top.
Summary of Contents for Ellisimo & Ellisimo BLSO-BF2
Page 1: ......
