23
EN
G
LIS
H
CHANGING THE PATTERN SIZE WHILE MAINTAINING
THE DESIRED THREAD DENSITY (STITCH RECALCULATOR)
In the embroidery edit screen, the size of the pattern
can be changed while the desired thread density is
maintained.
With this function, the pattern will be enlarged or
reduced at a larger ratio than with normal pattern
resizing.
a
Press .
b
Select the pattern to be resized, and then
press .
c
Press .
d
Press
to enter Stitch Recalculator
mode (
).
e
When the following message appears, press
.
→
The pattern will be returned to its original size,
angle, and position as it was before it was edited.
Note
• Be sure to sew trial embroidery using same fabric
and threads as project in order to check the sewing
results.
Note
• This function cannot be used with alphabet
character patterns, frame patterns or border
patterns. However, a border pattern can be edited
after this function has been used.
• Patterns with a large number of stitches (about
100,001 or more) cannot be resized while
maintaining a desired thread density. The maximum
limit for the number of stitches differs depending on
the data size of pattern.
• If this function is used, thread density is maintained
while the pattern is enlarged/reduced. However, the
needle drop point pattern is not entirely maintained.
Use the normal resizing mode
depending on the results of trial embroidering.
Memo
• Stitch Recalculator cannot be used if the key
appears as
.
