GETTING READY
24
Turn on the sewing machine.
Open the top cover.
Place the bobbin on the bobbin winder shaft so
that the spring on the shaft fits into the notch
in the bobbin
.
Press down on the bobbin until it snaps into
place.
a
Notch
b
Bobbin winder shaft spring
Slide the bobbin winder in the direction of the
arrow until it snaps into place.
•
/
(“Start/Stop” button) lights up in
orange.
Remove the spool cap that is inserted onto the
spool pin.
a
Spool pin
b
Spool cap
Place the spool of thread for the bobbin onto
the spool pin.
Slide the spool onto the pin so that the spool is
horizontal and the thread unwinds to the front at the
bottom.
• If the spool is not positioned so that the
thread unwinds correctly, the thread may
become tangled around the spool pin.
Slide the spool cap onto the spool pin.
Slide the spool cap as far as possible to the right, as
shown, with the rounded side on the left.
CAUTION
2
1
1
2
●
If the spool or the spool cap is not
positioned correctly, the thread may
become tangled around the spool pin and
the needle may break.
●
Three spool cap sizes are available
(large,medium and small), allowing you to
choose a spool cap that best fits the size
of spool being used. If the spool cap is too
small for the spool being used, the thread
may catch on the slit in the spool and the
needle may break.
●
Summary of Contents for Ellure PLUS BLR3
