Changing the Thread Spools with Designs of Eleven or More Colors
113
3
—————————————————————————————————————————————————————————————————————————————————————
Changing the Thread Spools with Designs of Eleven or
More Colors
This section provides details on the spool thread indicators and the change thread spools message in
addition to the procedure for easily changing the spools.
Memo
●
This feature is not available if “Manual
Color Sequence” has been set to “ON” in
the settings screen.
Change thread spools
message and spool
thread indicators
When it is necessary to replace the thread spool
while embroidering a pattern that contains eleven
or more colors, the machine automatically stops
sewing and the message shown below appears. At
the same time, the indicator on the spool stand for
the spool to be replaced lights up in white, then
flashes in the thread color of the next spool to be
installed.
When a new pattern is selected, the LCD message
and indicators warn you if the thread spools must
be changed. Change the thread spools according to
their new assignments.
1
The thread information for the thread spool
needs not to be changed appears in gray.
2
The thread information for the thread spool to
be changed appears in the new thread color
and framed in red.
3
Touch this key to close the message indicating
that the thread spool be changed.
1
Flashing in white, then lights up with the next
thread color (light turns off when indicates
black thread color)
2
The thread does not need to be changed on
spools where the LED is not flashing.
• Confirm the actual thread color number on
the LCD screen. The LED lights indicate the
approximate thread color to be used on
that particular spool.
After the necessary thread spools have been
changed, touch
to stop the flashing of the
spool stand indicator. Then, start embroidering.
Note
●
Touch needle bar key to move the needle
into the correct position for threading into
the new thread color. Refer to “Moving
and threading a selected needle bar” on
page 62.
●
When the embroidering screen appears,
the needle bar settings are saved.
●
If the needle bar settings are saved and the
next pattern that is opened contains thread
colors that are the same as those from the
previous pattern, the same needle bars will
be assigned the same thread colors from
the previous pattern.
●
The settings for the lighting and flashing of
the spool thread indicator can be changed.
For details, refer to “Specifying the spool
stand LED setting” on page 228.
●
If you wish to delete all assigned color on
display refer to “To cancel the thread color
settings for all previously stitched design”
on page 109.
3
1
2
2
Summary of Contents for Enterprise BNT10L
