16 |
www.babylock.com
Spool Pin and Thread Mast
To install the spool pin on the machine
1. You'll need the spool pin with nut and washer.
2. Remove the nut and washer.
3. Place the washer against the top of the
machine cover.
4. Screw the nut all the way up to the spool pin.
5. Place the spool pin through the washer and
into the top cover and tighten it all the way.
6.
Hold the spool pin firmly and tighten the nut
with the 8mm wrench (provided). Do not over
tighten.
To install the thread mast onto the machine
1. You'll need the thread mast with washer and
nut.
2. Remove the nut and washer.
3. Place the washer against the top of the
machine cover.
4. Screw the nut all the way up to the thread
mast.
5. Place the thread mast through the washer and
into the top cover and tighten it down to the
nut. Turn until the loop of the mast is directly
over the spool pin.
6.
Hold the thread mast firmly and tighten the
nut with a 10mm wrench (provided). Do not
over tighten.
Machine Head USB Port (built-in)
The USB port is located on the side of the machine to the LEFT of the display at the Front. This port can be
used to power a USB device or communicate with accessories. This port CANNOT be used to make machine
or display updates.
