Baby Lock Kinetic Frame, Assembly Instructions Manual

Baby Lock Kinetic Frame Assembly Instructions    27

Steps 15 & 16

Bungee Clamp Assembly

Hook & Loop Tape on Pole Assemblies

Fig. 15-1

Step 16: Hook & Loop Tape on Pole 

Assemblies

Parts needed

(1) frame assembly

(1) quilt top pole

(1) backing pole

(1) take-up pole

(3) hook & loop tapes QF00665

Tools Required

measuring tape or ruler (not provided)

scissors (not provided)

 NOTE: Take care to stick the hook & loop 

tape on straight. This step will determine how 

well your quilts load in the future. Use the 

Spring Coupler snap buttons as a guide when 

aligning the hook & loop tape for best results. 

16-1: Prepare to attach the Velcro to the quilt 

top pole, backing pole, and take-up pole, by 

measuring in 3-inch from each end of the pole. 

Peel the backing off the hook & loop tape as 

you go and apply to all three poles, starting 

at the 3-inch mark and ending at the opposite 

3-inch mark. Take care to stick the hook & 

loop tape on straight. This step will determine 

how well your quilts load in the future. Use the 

spring buttons as a guide when aligning the 

hook & loop tape for best results. Hint: Attach 

the hook & loop tape next to the snap buttons, 

not between.

Once the hook & loop tape has been adhered 

from one end of the poles to the other, it can 

be clipped where the poles meet at the  

pole coupler.

Step 15: Bungee Clamp Assembly

Parts needed

1- Frame Assembly

4- Bungee Clamps QF09318-110

15-1: Thread the bungee clamp cord from the 

inside of the frame through the bungee slot and 

then pull the cord in a downward movement to 

lock the bungee clamp into place. (Fig. 15-1)

15-2: Follow Step 15-1 for the remaining 

three bungee clamps.