Reinforcement Stitching
107
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
3
b
Attach buttonhole foot “A”.
• For details, refer to “Replacing the presser
foot” (page 39).
c
Select stitch
60
.
• For details, refer to “Selecting stitching” (page
70).
d
Position the fabric so that the opening of the
pocket faces toward you, and then lower the
presser foot lever so that the needle drops
2 mm (1/16 inch) in front of the pocket
opening.
a
2 mm (1/16 inch)
Pass the upper thread down through the hole in
the presser foot.
• When lowering the presser foot, do not push
in the front of the presser foot, otherwise the
bar tack will not be sewn with the correct
size.
a
Do not reduce the gap.
e
Pull down the buttonhole lever as far as
possible.
a
Buttonhole lever
The buttonhole lever is positioned behind the
bracket on the buttonhole foot.
a
Buttonhole lever
b
Bracket
f
Gently hold the end of the upper thread in
your left hand, and then start sewing.
X
Once sewing is completed, the machine
automatically sews reinforcement stitches,
then stops.
g
Cut the threads, raise the presser foot lever,
and then remove the fabric.
h
Raise the buttonhole lever to its original
position.
Memo
z
If the fabric does not feed, for example,
because it is too thick, increase the stitch
length. For details, refer to “Adjusting the
stitch length” (page 58).
1
a
a
2
1
Summary of Contents for Melody BLMY
Page 1: ......
Page 48: ...GETTING READY 46...
Page 157: ...Index 155 4...
Page 158: ...NewF3_dash_TaconyEng_coverH1 H4...
