GETTING READY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
22
Memo
z
When sewing with fine, cross-wound thread,
use the small spool cap, and leave a small
space between the cap and the spool.
a
Spool cap (small)
b
Spool (cross-wound thread)
c
Space
z
When using thread that winds off quickly,
such as transparent nylon thread or metallic
thread, place the spool net over the spool
before placing the spool of thread onto the
spool pin.
If the spool net is too long, fold it to fit the
size of the spool.
When the spool net is used, the tension of
the upper thread will slightly increase. Be
sure to check the thread tension. For details,
refer to “Adjusting the Thread Tension”
(page 55).
a
Spool net
b
Spool
c
Spool cap
d
Spool pin
h
While holding the thread near the spool with
your right hand, as shown, pull the thread with
your left hand, and then pass the thread
behind the thread guide cover and to the front.
a
Thread guide cover
i
Pass the thread under the thread guide plate,
and then pull it to the right.
a
Thread guide plate
j
Pass the thread under the hook on the thread
guide, and then wind it counterclockwise
under the pretension disk.
a
Thread guide and pretension disk
Note
z
Make sure that the thread passes under the
pretension disk.
a
c
b
2
1
4
3
1
1
1
1
Summary of Contents for Melody BLMY
Page 1: ......
Page 48: ...GETTING READY 46...
Page 157: ...Index 155 4...
Page 158: ...NewF3_dash_TaconyEng_coverH1 H4...
