Useful Functions
61
2
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Automatically cutting the
thread
The sewing machine can be set to automatically cut
the threads at the end of the stitching. This is called
“programmed thread-cutting”. If programmed thread-
cutting is set, automatic reverse/reinforcement
stitching is also set. This setting is convenient if a
stitch for sewing buttonholes or bar tacks is selected.
a
Turn on the sewing machine.
X
The LCD comes on.
b
Select a stitch.
• For details on selecting a stitch, refer to
“Selecting stitching” (page 70).
c
Press
(Automatic thread cutting key).
X
(Automatic thread cutting key) and
(Automatic reverse/reinforcement stitch
key) light up, and the sewing machine is set
for programmed thread-cutting and
automatic reverse/reinforcement stitching.
• To turn off programmed thread-cutting, press
(Automatic thread cutting key) until the
key is no longer lit.
• When the sewing machine is turned off, the
programmed thread-cutting setting is
cancelled.
d
Position the fabric under the presser foot, and
then press
/
(“Start/Stop” button)
once.
a
“Start/Stop” button
X
After reverse/reinforcement stitches are
sewn, the machine starts sewing.
e
After reaching the end of the stitching, press
(“Reverse/Reinforcement Stitch” button)
once.
This step is not necessary if a stitch such as
those for sewing buttonholes and bar tacks is
selected where reinforcement stitches are
automatically sewn.
a
“Reverse/Reinforcement Stitch” button
X
After reverse/reinforcement stitches are
sewn, the sewing machine stops and cuts the
thread.
Memo
z
Reverse/reinforcement stitches
WILL NOT
be sewn and the thread will not
automatically be cut until
(“Reverse/
Reinforcement Stitch” button) is pressed.
/
(“Start/Stop” button) may be
pressed to stop stitching when needed such
as for pivoting corners.
1
1
/
The thread is cut here.
Summary of Contents for Melody BLMY
Page 1: ......
Page 48: ...GETTING READY 46...
Page 157: ...Index 155 4...
Page 158: ...NewF3_dash_TaconyEng_coverH1 H4...
