f
fig A-6
fig A-7
g
fig A-8
h
i
j
fig A-9
- 3 -
6. Stand up the machine.
The terminal cover will come out.
Insert the screwdriver into the hole of machine from
backside.
Hook the tip of driver into the groove of forward-
reverse adjusting knob (f). (fig A-6)
Slide them to the left and remove the knob.
7. Hook the tip of screwdriver to the front cover holder (g)
and pull down. (fig. A-7)
8. Tilt the machine backward again.
Hold the machine casting and push the left bottom
corner (h) of front cover upward. The hook inside of the
cover will come off. (fig. A-8)
9. Bring up the front cover carefully.
Disconnect the two cord connectors (i, j) from the CPU
curcuit board. (fig. A-9)
Terminal
cover
