a
b
c
fig. A-1
fig. A-2
fig. A-3
fig. A-4
d
fig. A-5
e
- 2 -
A.REMOVING THE FRONT COVER
1. Remove the set screw (a) and the light cover. (fig. A-1)
2. Remove the left side screw (b) inside the thread take
up lever cover. (fig. A-2)
3. Remove the screw (c) located on the backside of
machine, above the spool pin. (fig. A-3)
4. Tilt the machine backward.
Remove the 4 screws (d) and base. (fig. A-4)
5. Remove the 2 screws (e) on the bottom of front cover.
(fig. A-5)
