WINDING THE BOBBIN
WINDING THE BOBBIN
1. Place the spool of thread and spool cap onto the
spool pin. For smaller spools of thread, use the
small spool cap.
Spool cap should be close in size to the thread
spool, however should not be any smaller. If the
spool cap is smaller than thread spool, thread
may get caught in the slit on end of spool and
cause damage.
1
2
Bobbin winding
2. Bring the hinged thread guide up and forward
into the upright position.
20
2
1
4
5
7
6
3
12
8
Note:
Due to the independent bobbin winder motor, you can wind the bobbin during sewing.
Follow the steps for "Winding The Bobbin" except place the thread for the bobbin through
the thread guide opening not in use being careful not to tangle thread.
Summary of Contents for Quest PLUS BLQ2-PL
Page 1: ......
