5. Pass the upper thread down through the hole
in the presser foot. Pull down the buttonhole
lever and position it behind the bracket on the
buttonhole foot. Gently hold the end of the
upper thread in your left hand, and then start
sewing.
Note:
When you start to sew darning
pattern before the buttonhole lever is
lowered, LCD screen will show the
animated warning message to remind you
to lower the buttonhole lever.
7. If the tear is too large to cover with one darning
pattern, reposition the fabric and sew additional
darning patterns for better coverage.
7
5
6. Darning stitches are sewn from the front of
the presser foot to the back, as shown.
64
6
The evenness of darning
may vary depend
ing on the sewing condition
type of fabrics
You can correct the unevenness of darning
.
- Press the " " button.
A. If the left corner is lower than the right side,
press the stitch length adjusting button "+".
B. If the right corner is lower than the left side,
press the stitch length adjusting button "".
adjusting
adjusted.
stitch
-
, i.e.
.
stitch
- Press the "
" button again after
to
return to the normal LCD screen.
Note:
Only Group 2-B patterns 46-48 can
be
To adjust the evenness of darning stitch
A
B
Summary of Contents for Quest PLUS BLQ2-PL
Page 1: ......
