30 |
www.BabyLock.com
Low Bobbin
The Regent includes a low bobbin alarm to
estimate how soon the bobbin thread will run
out. This low bobbin capacity is based on an
estimate of how much of a particular thread
can fit on a bobbin, in combination with other
quilting factors such as tension, stitches per
inch, and how much bobbin thread is used to
pull up and tie off when beginning and ending
quilting.
To estimate how much thread is on a bobbin,
place a full bobbin in the machine, press the red
Record button
“A”
, and quilt as usual.
When the bobbin runs out, press the top left
button to Stop Recording. Note the number that
is indicated under the Bobbin Thread Capacity
“B”
. Use the “–” button to reduce the number
by 15 to 20 so the alarm will sound before the
bobbin runs out. Save the reduced number
as one of the Bobbin Thread Capacity Presets
“D”
. Make a note as to which type of thread the
preset represents.
D
A
C
B
E
F
BUTTON ICONS:
A = Record/Stop
B = Bobbin Thread Capacity
C = New Bobbin
D = Save Preset
E = Set Alarm
F = Preset Value
Put a new bobbin with the same thread into the machine and press the New Bobbin button
“C”
. Then
press the Alarm button
“E”�
As you quilt, the remaining bobbin thread value will estimate how much
thread remains on the current bobbin, and when you reach the capacity value, an alarm will sound
warning that the bobbin is nearly out of thread.
When operating in manual mode, the low bobbin function assumes stitching at approximately the last
SPI setting on the regulated screen. If the SPI setting was below 8 stitches per inch, the function will
assume you will quilt at 10 stitches per inch. It is advisable therefore to set the stitches per inch on the
regulated screen before you change to manual mode.
Three Bobbin Thread Capacity preset values can be stored – one for each of three different types of
thread. Simply go through the record process with a full bobbin of that type of thread and then store
the capacity as a preset. Press the corresponding preset button
“F”
, insert a full bobbin with that type of
thread, and press New Bobbin button to start.
