Note:
If the thread spool does have a slit
on the end, it is recommended to place
this end of the spool toward the bottom,
so it doesn't get caught while sewing or
bobbin winding.
Note:
Due to the independent bobbin winder motor, you can wind the bobbin during sewing.
Follow the steps for "Winding The Bobbin" except place the thread for the bobbin through
the thread guide opening not in use being careful not to tangle thread.
WINDING THE BOBBIN
Bobbin winding
26
2. Place the spool of thread and spool cap onto
the spool pin. For smaller spools of thread,
use the small spool cap.
Spool cap should be close in size to the thread
spool, however should not be any smaller. If the
spool cap is smaller than thread spool, thread
may get caught in the slit on end of spool and
cause damage.
2
1
1. Bring the hinged thread guide up and forward
into the upright position.
1
2
4
5
3
11
7
6
8
Attention:
The included bobbin was designed
specifically for this sewing machine. If bobbins
from other models are used, the machine will
not operate correctly. Use only the included
bobbin or bobbins of the same type / class.
8.95 mm
(approx.
3/8 inch)
Class L
Class 15
This model
Other models
Actual Size
Summary of Contents for Serenade BLSN
Page 1: ......
Page 119: ...021S2A0101 baby lock BLSN S20A IBBLSN Jul 10 ...
