USING THE CAMERA TO CONNECT PATTERNS
145
Ad
va
nc
ed
Ed
iti
n
g
3
w
Lower the embroidery foot, and then
embroider the third pattern.
When embroidering is finished, the following
message appears. When finished connecting
patterns, touch
.
After embroidering is finished,
is no longer
located at the bottom right of LCD screen.
The three patterns have been connected.
Changing the Position of a Sticker
If the selected pattern or embroidery positioning
stickers for connecting the next pattern do not easily fit
in the embroidering area, follow the on-screen
instructions that appear after step
o
on page 142 in
order to move the embroidery positioning stickers.
For an example, the on-screen instruction appears
when you use the embroidery frame with a size of 10
cm × 10 cm (4 inches × 4 inches) to connect patterns as
shown below.
a
Pattern A
b
Pattern B
a
Refer to steps
a
through
o
of
“Connecting Three Patterns” using the
embroidery frame with a size of 10 cm × 10
cm (4 inches × 4 inches) to embroider the
first pattern and to connect the second
pattern.
b
Following message appears in step
p
if the
next pattern or affixed embroidery
positioning stickers are close to being out of
the embroidering area. Follow the
instructions and then touch
.
a
Embroidering area
a
First pattern that was embroidered
b
Pattern to be embroidered next
Note
• If the following message appears, rehoop the
fabric as indicated in the screen, and then
touch .
a
a
b
Summary of Contents for Solaris VISION BLSA3
