TROUBLESHOOTING
192
If the machine stops operating correctly, check the
following possible problems before requesting
service.
You can solve most problems by yourself. Visit us
at “ www.babylock.com ”.
If the problem persists, contact your authorized
Baby Lock retailer.
If the Thread Becomes Tangled
Under the Bobbin Winder Seat
If the bobbin winding starts when the thread is not
passed through the pretension disk correctly, the
thread may become tangled beneath the bobbin
winder seat.
Wind off the thread according to the following
procedure.
a
Thread
b
Bobbin winder seat
a
Touch
once to stop the bobbin
winding.
b
Cut the thread with scissors near the
pretension disk.
a
Pretension disk
c
Push the bobbin winder switch to the right,
and then remove the bobbin from the shaft
and cut the thread leading to the bobbin in
order to be able to completely remove the
bobbin from shaft.
d
Hold the thread end with your left hand,
and wind off the thread clockwise from
under the bobbin winder seat with your
right hand as shown below.
TROUBLESHOOTING
CAUTION
• Do not remove the bobbin winder seat even if
the thread becomes tangled under the bobbin
winder seat. The cutter in the bobbin winder
seat may cause injury.
a
Summary of Contents for Solaris VISION BLSA3
