TROUBLESHOOTING
194
■
While Embroidering
Pointer of the
projector does not
indicate the position
correctly.
With thick elastic fabric, the position will be
misaligned only at raised parts in the fabric.
Manually adjust the position according to the
thickness of the fabric.
43
With fabric having a very uneven surface, the
position is not correctly aligned.
The pointer indication should be used only as
a reference.
—
Problem
Cause
Solution
Page
Machine does not
operate.
“Start/Stop” button was not pressed.
Press the “Start/Stop” button.
—
There is no pattern selected.
Select a pattern.
40
Embroidery foot is not lowered.
Lower the embroidery foot.
—
Needle breaks.
Needle is installed incorrectly.
Reinstall the needle correctly.
11
Needle clamp screw is not tightened.
Tighten the needle clamp screw.
11
Needle is turned or bent.
Replace the needle.
11
Using improper needle or thread for the
selected fabric.
Check the needle and fabric combination.
11, 49
Wrong embroidery foot was used.
Use the recommended embroidery foot.
10
Upper thread tension is too tight.
Adjust the thread tension.
92
Fabric is pulled during embroidering.
Do not pull the fabric during embroidering.
—
Spool cap is set incorrectly.
Check the method for attaching the spool cap,
then reattach the spool cap.
21
There are scratches around the opening in the
needle plate.
* There is a notch on the left side of the
opening in the needle plate. This is not a
scratch.
Replace the needle plate, or consult your
authorized Baby Lock retailer.
—
There are scratches around the opening in the
embroidery foot.
Replace the embroidery foot, or consult your
authorized Baby Lock retailer.
9
There are scratches on the bobbin case.
Replace the bobbin case, or consult your
authorized Baby Lock retailer.
—
Needle is defective.
Replace the needle.
11
A bobbin designed specifically for this
machine is not used.
Use a bobbin designed specifically for this
machine.
15
Upper threading is incorrect.
Check the steps for threading the machine and
rethread the machine.
21
Bobbin is set incorrectly.
Reset the bobbin thread correctly.
19
Embroidery foot is attached incorrectly.
Attach the embroidery foot correctly.
9
Screw of the presser foot holder is loose.
Securely tighten the screw of the presser foot.
10
Fabric is too thick.
Use fabric that the needle can pierce when the
handwheel is turned.
—
Stabilizer is not attached to fabric being
embroidered.
Attach stabilizer.
26
Bobbin thread is incorrectly wound.
Use a correctly wound bobbin.
15
Problem
Cause
Solution
Page
a
Notch
a
Summary of Contents for Solaris VISION BLSA3
