Reinforcement Stitching
Sewing
S-37
U
T
IL
ITY S
T
IT
CH
ES
S
d
Position the fabric so that the needle is 2 mm (1/16
inch) in front of the area to be darned.
1
Tear
2
2 mm (1/16 inch)
Pass the upper thread down through the hole in the
presser foot, and then lower the presser foot.
• When lowering the presser foot, do not push in the
front of the presser foot, otherwise the darning will
not be sewn with the correct size.
1
Do not reduce the gap.
e
Pull down the buttonhole lever as far as possible.
1
Buttonhole lever
The buttonhole lever is positioned behind the bracket
on the buttonhole foot.
1
Buttonhole lever
2
Bracket
f
Gently hold the end of the upper thread in your left
hand, and then start sewing.
g
Raise the presser foot lever, remove the fabric, and
then cut the threads.
h
Raise the buttonhole lever to its original position.
2
1
a
a
2
1
Memo
• If the fabric does not feed, for example, because it
is too thick, increase the stitch length. For details,
refer to “Setting the stitch length” in the “Basic
operations” section.
Summary of Contents for Soprano BLMSP
