NAMES OF MACHINE PARTS AND THEIR FUNCTIONS
B-14
Embroidery Unit
a
Carriage
The carriage moves the embroidery frame automatically when
embroidering. (page B-65)
b
Release button (located under the embroidery unit)
Press the release button to remove the embroidery unit.
(page B-65)
c
Embroidery frame holder
Insert the embroidery frame into the embroidery frame holder
to hold the frame in place. (page E-17)
d
Frame-securing lever
Press the frame-securing lever down to secure the embroidery
frame. (page E-17)
e
Embroidery unit connection
Insert the embroidery unit connection into the connection port
when attaching the embroidery unit. (page B-65)
Operation Buttons
a
“Start/Stop” button
Press this button and the machine will sew a few stitches at a
slow speed and then begin sewing at the speed set by the
sewing speed controller. Press the button again to stop the
machine. Hold the button in to sew at the machine’s slowest
speed. The button changes color according to the machine’s
operation mode.
b
“Reverse Stitch” button
For straight, zigzag, and elastic zigzag stitch patterns that take
reverse stitches, the machine will sew reverse stitches at low
speed only while holding down the “Reverse Stitch” button.
The stitches are sewn in the opposite direction. For other
stitches, use this button to sew reinforcement stitches at the
beginning and end of sewing. Press and hold this button, and
the machine sews 3 stitches in the same spot and stops
automatically. (see page S-5)
c
“Reinforcement Stitch” button
Use this button to sew a single stitch repeatedly and tie-off. For
character/decorative stitches, press this button to end with a
full pattern instead of mid-point. The LED light beside this
button lights up while the machine is stitching the last full motif,
and automatically turns off when the sewing is stopped. (see
page S-5)
d
“Needle Position” button
Use this button when changing sewing direction or for detailed
sewing in small areas. Press this button to raise or lower the
needle position. With this button, you can lower and raise the
needle to sew a single stitch.
e
“Thread Cutter” button
Press this button after sewing to automatically trim the excess
thread.
f
“Presser Foot Lifter” button
Press this button to lower the presser foot and apply pressure
to the fabric. Press this button again to raise the presser foot.
g
Sewing Speed controller
Use this controller to adjust the sewing speed. Move the slide
to the left to sew at slower speeds. Move the slide to the right
to sew at higher speeds. Beginners should sew at a slow
speed.
h
“Automatic Threading” button
Use this button to automatically thread the needle.
CAUTION
• Before inserting or removing the embroidery
unit, turn the main power to OFF.
• After the embroidery frame is set in the frame
holder, be sure the frame-securing lever is
correctly lowered.
Green:
The machine is ready to sew or is sewing.
Red:
The machine cannot sew.
Summary of Contents for Urity BLTY
