SELECTING/EDITING/SAVING PATTERNS
163
5
c
Hold the clip end of the USB cord clamp,
and then firmly insert the other end into the
screw hole where the protective cap was
removed.
d
As described in steps
a
through
c
,
remove the protective cap from the rear
screw hole on the side of the machine, and
then insert an opened USB cord clamp.
e
Check that the USB cord clamps have been
firmly inserted into the front and rear screw
holes on the side of the machine.
• If the USB cord clamps are not firmly inserted into the
screw holes, they are not correctly installed. Firmly
insert the cord clamps into the screw holes.
f
Pass the USB cable through the front USB
cord clamp, and then close the clamp to
secure the cable.
g
Using the same operation described in step
e
, secure the USB cable with the rear USB
cord clamp.
h
Arrange the USB cable between the USB
cord clamps so that the cable does not
interfere with the operation of the machine.
Note
• When passing the USB cable through the
clamp, do not insert it with excessive force;
otherwise, the clamp may break.
Memo
• Store the protective caps, which were
removed in step
a
, in the included
accessory case so they will not be lost.
