GETTING READY
25
1
Setup location
Set up the machine in a location that meets the following requirements.
• Position the machine a minimum of 50 mm (2 inches) away from the wall
• Allow sufficient space around the machine
• Place no objects within the moving range of the embroidery frame
• Set-up machine near an electrical outlet
• Use a level and stable surface, such as a desk or stand.
• Use a surface that can support the weight of the machine (about 42.5 kg (94 lb))
• Allow open space around the ventilation slots found on the rear underside of the machine
785 mm
(31 inches)
Minimum of
50 mm
(2 inches)
589 mm
(23-1/4 inches)
More than
350 mm
(13-3/4 inches)
More than
210 mm
(8-1/4 inches)
560 mm
(22 inches)
More than
220 mm
(8-3/4 inches)
CAUTION
• In order to prevent malfunctions or damage, do not set up the machine in a location exposed to the
following conditions.
Liquids, such as water
Extreme dust
Direct sunlight
Insufficient space
Blocked ventilation slots
Objects within the moving range of the
embroidery frame
An unstable surface
Extremely high or extremely low
temperatures. The operating environment
should be between
5 °C (40 °F) and 40 °C (104°F).
Connection to extension cords or
multiple adapters
Note
• For your safety: Since the machine weighs approximately 42.5 kg (94 lb), do not set it up on an
unstable table or desk.
