APPENDIX
273
7
Installing the embroidery frame
holder
After embroidering using the cap embroidery
frame is finished, remove the needle plate spacer
and cap frame driver, and then re-attach the
embroidery frame holder.
a
Remove the needle plate spacer.
1
Needle plate spacer
b
Loosen the two lower thumb screws.
1
Thumb screws
c
Remove the two upper thumb screws.
1
Thumb screws
d
Remove the cap frame driver.
e
With the hole on the sweat guard holder
aligned with the centerline of the guiding
plate, insert the two thumb screws removed
in step
c
into the holes at the top, and then
tighten the thumb screws.
1
Hole on the sweat guard holder
2
Centerline of guiding plate
3
Holes on the top
• Insert the thumb screws into the holes where the cap
frame driver that was originally installed (holes that
the thumb screws were removed from in step
b
on
page 262).
→
The movable section of the cap frame driver is
secured.
Note
• Be careful that the cap frame driver does
not hit any nearby parts, such as the
presser foot.
