BABY MONSTERS SWING & FLAT, Manual

CLOSING THE ROCKER

ROCKING

SAFETY HARNESS

To close the rocker or change seat positions, lift the seat latch until it clicks open. Release the horizontal 

locking bar from the locking pins, and gently lower the seat to the desired position.

Important warning: always test that all latches are securely engaged before use.  

Your  Rock  can  be  used  in  either  a  stationary  or  rocking 

position.

Rocking position:

Locate the Rocker buttons found on the rear of each rocker 

arm.

Slide the Rocker button inward as indicatedby the arrows, while 

simultaneously  swinging  the  rocker  arm  down  to  create  the 

curved rocker bar.

Stationary position:

To  allow  the  Rocker  to  sit  flat  on  the  floor  in  a  stationary 
position, reverse the above procedure.

1. Release the safety harness by squeezing the buckle prongs 

    simultaneously and then pulling the buckle out 

    from the centre latch.

2. Repeat on the other buckle.

Swing & Flat is equipped with a 5-point adjustable harness system.

The shoulder harness is adjustable to 2 height positions and can be changed by unsnapping the hook from the 

waist strap, and then pushing the shoulder harness through the seat fabric, then rethreading 

through the other position. Repeat on the other side shoulder strap.

The length of the shoulder straps can also be changed by sliding the adjustment buckle on each shoulder strap. 

The waist belts are adjustable on either the right or left by using the adjustment buckles on the waist strap.

To use the 5-point harness, insert the 2 waist strap tongues into the center crotch strap buckle from the right 

and left. The shoulder straps do not need to be detached each time the child is removed or seated in the 

stroller.

WARNING: Always fasten the 5-point harness securely and properly around the child’s body whenever 

the child is seated in the Rocker.

WARNING: Never leave the child unattended in the rocker.

English