39
40
2. Store UAS Connectors in the storage location on
the bottom of the base. (Fig 39-1)
3. If vehicle seat back is adjustable, adjust into the
upright position or the position or the position
specified in the vehicle owner’s manual for use
with a Car Seat.
4. Snap Car Seat into Base and place Car Seat
and Base onto the vehicle seat in the rear-facing
position in the vehicle seating location selected.
Check for the correct seat recline and adjust
recline as necessary. (Fig 39-2) See Section 11.4
Adjust Seat Recline Angle
.
5. Remove any toys or other objects attached to the
carry handle before installing car seat in vehicle.
6. Remove the Car Seat from the base by
squeezing the base release handle located under
the center of the foot end of the Car Seat and
lifting upward on the Car Seat. (Fig 39-3)
7. Place the Base in the rear-facing position in a
forward facing vehicle seat with Base contacting
vehicle seat back as shown in (Fig 39-4).
10.0
Securing Car Seat in Your Vehicle
10.0
Securing Car Seat in Your Vehicle
39-1
39-2
10.3.2 Secure Base WITH Vehicle
Combination Lap/Shoulder Belt
1. To secure base with Vehicle Combination Lap/
Shoulder Belt: slide lap portion of the vehicle lap/
shoulder belt into the Vehicle Belt Path openings,
position vehicle shoulder belt against vehicle seat
back and buckle vehicle seat belt as shown in
(Fig 40-1).
Note: A locking clip must be used with all
combination Lap/Shoulder belt installations with
children weighing more than 22 lbs (10 kg).
10.3.3 Secure Base WITH
Vehicle Lap Belt only
1. To secure attach Base with Vehicle Lap Belt only:
slide the vehicle lap belt into the Vehicle Belt Path
openings, and buckle vehicle belt as shown in (Fig
40-2).
10.3.4 Tightening Vehicle Seat Belt
1. Check that lap belt is not twisted.
2. Proper installation of the Base requires that the vehicle lap belt be very
tight and stay tight.
39-4
39-3
40-1
40-2
10 kg
under
10 to
14.5 kg
(22 to 32 lbs./livres)
(22 lbs./livres) and
