69
70
13.0
Securing Backless Booster Seat in Vehicle
13.0
Securing Backless Booster Seat in Vehicle
13.4 Installation with LATCH System
If a LATCH attachment system is not available or will not be used, go to
next section.
1. Adjust Recline Foot into the fully extended
position. Pull out on the Recline Handle
while pressing down on the Recline Foot
and lift up on the front of the Car Seat.
(Fig 70-1)
2. If vehicle seat back is adjustable, adjust
into the upright position or the position
or the position specified in the vehicle
owner’s manual for use with a Car Seat.
3. Extend LATCH Connectors by pressing
the LATCH Extend Button on each side
as shown. (Fig 70-2)
4. Place the booster seat in a forward-
facing, LATCH equipped vehicle seat.
5. Attach the LATCH Connectors to the
vehicle LATCH lower anchorages, pull
to check that LATCH Connectors are
securely attached. (See section 10.1)
3. As the U-bar slides into the hatch, press
the two spring release buttons (located
on each side of the U-bar) while pushing
the U-bar down to allow the U-bar to
snap securely into place. (Fig 69-1)
The Back Support MUST be securely
installed before using the Car Seat/
Booster seat.
4. Reattach the Seat Pad to the seat back
by pulling the fabric loops on the back of
the Seat Pad through the small holes in
the seat back and hooking them on the
tabs. (Fig 69-2)
5. Push the Back Support backward until it
clicks into its locked position. (Fig 69-3)
Pull to make sure the Back Support is
securely locked into place.
NOTE: If using in Toddler Car Seat
mode with the built-in safety harness,
refer to Section 12.1.3 Reinstalling
the Built-in Safety Harness.
69-1
69-2
69-3
70-2
70-1
Seat pad
Tab
Front view
Back view
Summary of Contents for FastBack
Page 42: ...81 82 Note Note...
