Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
5
6
ASSEMBLY
ASSEMBLY
TO ASSEMBLE BOOSTER SEAT
•
ONLY
approved
SNAP TECH
TM
products can be
used on the frame.
5)
• Slide Footrest posts into the front of the
Seat until it clicks into place (Fig. 5a).
• Connect the Seat and lock into place (Fig.
5b). Pull up and make sure it’s locked
firmly in place before use (Fig. 5c).
2)
• Squeeze the Release Handles on both
sides simultaneously and push the tube
through the Height Adjusters until it locks
in the highest position (Fig. 2).
3)
• Insert the legs into the ends of the Front
tube of both the right and left Upper
Frame Assemblies (Fig. 3a).
Note:
Legs are properly connected
when the locking pins are lined up with
the holes on the ends of the Upper
Frame Assemblies. Make sure the
locking pins are engaged before use.
• Insert the other Legs into the ends of
the Rear tube of both the right and left
Upper Frame Assemblies (Fig. 3b).
Note:
Legs are properly connected
when the locking pins are lined up with
the holes on the ends of the Upper
Frame Assemblies. Make sure the
locking pins are engaged before use.
4)
• Attach each of the Casters to the high
chair leg (Fig. 4). Snap casters into
bottom of the leg. Check that all four
Casters are securely fastened to the
high chair.
Release Handle
Fig. 2
Fig. 3a
Fig. 3b
Fig. 4
Fig. 5a
Fig. 5b
Fig. 5c
