ASSEMBLY
ASSEMBLY
7
8
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
PARENT TRAY
WARNING:
Do
not place hot liquids or
more than 3 pounds in
the parent tray. Serious
burns or unstable
conditions could result.
7)
•
To attach parent tray:
Snap the
upper portion of the tray over the
handle (Fig 7a).
• Attach the lower portion of the parent
tray to the cross tube, with the screws
provided (Fig. 7b).
NOTE:
Check to make sure the
parent tray is secure before using.
SEATBACK POSITIONING
9)
•
To recline the seat:
loosen the strap
through the buckle and adjust to the
required recline position (Fig. 9a). To
place the seat back in a more upright
position, press upward on the seat
back with one hand while pulling the
strap through the buckle with the other
(Fig. 9b).
NOTE:
The upright position should
be used
only for a child that is at
least 6 months old
. Always re-adjust
the safety harness, including the
shoulder belts, when repositioning the
seatback.
BUMPER BAR
WARNING:
Do not
use bumper bar to carry
seat with child inside.
The bumper bar is not a
carrying handle.
10)
• Attach the bumper bar by lining up
anchors with the slots on the seat.
Push until it locks into place (Fig.
10a).
NOTE:
The bumper bar must be
securely attached before using this
product.
• To detach bumper bar, press the
release button on the bottom of the
bar and pull bar out of the anchor.
Swing the bar out to access the seat
(Fig. 10b).
Fig. 7a
Fig. 7b
Fig. 8a
Fig. 8b
CANOPY
8)
•
To open the canopy:
push forward
on the front edge of the canopy.
Push downward on the tensioners
to secure (Fig. 8a).
•
To fold the canopy:
pull upwards
on the tensioners and then pull
backwards on the front edge (Fig.
8b).
Fig. 9b
Fig. 9a
Fig. 10a
Fig. 10b
