background image

* Remove stroller from box. The front wheels, rear wheels, child tray, and 

parent tray need to be installed prior to use.

*  To  attach  the  front  wheels,  unfold  stroller  as  described  in  the  section 

following.  See figure 1.

   Lean the stroller backwards so that it rests on the handle and rear frame 

tubes and the front wheel tubes are pointing upward.  

* Position the front wheel assembly at the front tube such that the hole in the 

swivel assembly will slide onto the front tube.  Pull upward on the boot 
to expose the push button.  Push each front wheel assembly onto the front 
tube being careful that wheel assembly locks onto the push button on the 
front leg.  Pull on the wheel assembly to ensure that it is securely attached 
to the stroller.  Please see figure 2a and 2b.

* Assemble the rear axle as follows:  Insert the axle through each wheel and 

lock in place with the light colored locking washer.  Please see figure 3a.  
Snap the cap into the recess in the wheel.  Please see figure 3b.  Pull on 
each wheel to ensure that each is firmly attached to the axle. 

* Lean the stroller forward to rest on the front wheels. 

Lift upward on the 

rear tube of the basket to lock in the up position. See figure 11. 

 To attach 

the rear wheels, position the rear axle and wheel assembly such that the 
brake levers are facing to the rear of the stroller.  Press the rear wheel 
assembly onto the rear frame tubes being careful that the push buttons on 
the front of each rear tube engage the hole on the front of each rear wheel 
housing.    Pull  on  the  rear  wheel  assembly  to  ensure  that  it  is  securely 
attached to the stroller.  Please see figure 4.

     Ensure that the wheels are firmly locked into place. Do Not use the stroller 

if the wheels are not locked into place, but rather contact our customer 
service department immediately at (800) 328-7363, between the hours of 
8:00am and 4:30pm PCT, for assistance

   

TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE 

INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Car Seat

Front Wheels

Parent Tray

PARTS

TO ASSEMBLE STROLLER

Child Tray

Rear Axle

Solid Cap

Locking Cap

Rear Wheels

Stroller

Figure 1.

Base

Car Seat

Hub Cap

Front Wheels

3

Locking

Cap

Solid

Cap

Fig. 2b

Fig. 2a

Fig. 3a

Fig. 3b

Fig. 4

Summary of Contents for Profile Travel System










Reviews: