Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
7
8
SAFETY
SAFETY
position that places the shoulder strap level
with, or below the top of the child’s shoulder
and feed the shoulder harness under the
correct loop. To adjust harness slot unhook
the shoulder strap from the crotch buckle.
(Fig. 18) Feed the shoulder strap through the
harness spread slots. You can access these
slots from the rear of the seat. Feed shoulder
strap through appropriate slot and reattach
shoulder strap to crotch buckle.
• Carefully place the child in the stroller seat
and bring the safety harness around the child’s
waist and over the shoulders. Place the crotch
strap and between the child’s legs. Insert the
male end of each shoulder / waist belt into
the buckle on the crotch strap. Tighten the
harness to be snug around the child’s waist
and over the child’s shoulders. (Fig.19)
• To release, apply pressure to both sides of
each male clip until the clip is released.
(Fig. 20) This process requires a moderate
amount of effort so as to prevent an accidental
release by your child.
NOTE:
Buckles may be hard to release when
1st used.
TRAVEL SYSTEM - Safety Belt
• Strap the safety belt over the infant car seat
through the seat belt slots on the infant car
seat, connect the buckles together (Fig. 21).
The safety belts for the infant car seat is
located in small pockets on outer sides of seat
pads. Tighten the strap so the infant car seat
fits snug and can't move.
IT IS VERY IMPORTANT THAT THE
INFANT CAR SEAT STRAP IS ALWAYS
TIGHTLY FASTENED AROUND THE
INFANT CAR SEAT.
NOTE:
When the stand feature safety belt
is not used, you must store the stand feature
safety belt back to its storage.
JUMP SEAT - 3-Point Harness
• Secure the child with the jump seat 3-point
harness (Fig. 22) when child is sitting on the
jump seat.
PLATFORM - Safety Belt
• Secure the stand feature safety belt behind
child and engate buckle (Fig. 23). This is the
same safety belt you use to secure the rear
infant car seat.
TO RECLINE SEAT
FRONT SEAT
The front seat has a two position recline. To
recline the seat, rotate the recline bar and press
backward on the seat back. (Fig. 24) To place the
seat in the upright position, press upward on the
seat back while rotating the recline bar.
WARNING:
The upright
position should be used only for a
child that is at least 6 months old.
TO ATTACH INFANT CAR SEAT
To attach Baby Trend infant car seats (Fig. 25),
rotate child trays to the vertical postion first. See
rotate child tray for more details.
WARNING:
Avoid serious
injury from falling, ALWAYS use
the safety belt to secure both of
FRONT and REAR car seats.
Attach the front infant car seat:
Recline the front seat back. Postion the infant car
seat, facing toward the rear of the stroller, so the
seat shell goes into the front child tray and latches
into place. (Fig. 26)
Fig. 19
Shoulder Strap
Squeeze
Adjust for a snug fit
Crotch Strap
Waist Strap
Fig. 20
Fig. 21
Fig. 22
Fig. 23
Fig. 24
Fig. 25
Fig. 26
