background image

 Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.

 Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.

Check that the infant car seat is firmly locked onto 

the child tray then 

STRAP THE SAFETY BELT 

OVER THE CAR SEAT

 through the seat belt 

slots on the infant car seat, connect the buckles 

together. (Fig. 27) Tighten the strap so the infant 

car seat fits snug and can't move. 

 

IT IS VERY IMPORTANT THAT THE INFANT 

CAR SEAT STRAP IS ALWAYS TIGHTLY 

FASTENED AROUND THE INFANT CAR 

SEAT. 

DO NOT USE INFANT CAR SEAT 

WITHOUT THE SAFETY BELT.

 

To remove infant car seat: 

Unfasten the safety belt and store in pocket 

located on each side of seat, then squeeze the 

release handle located at the foot-end of the infant 

car seat and carefully lift upward. (Fig. 28)

 

JUMP SEAT

 

 

 

SIT ON JUMP SEAT 

Have the child sit on the jump seat facing 

backwards. Secure the child with the jump seat 

3-point harness. Part of the 3-point harness is 

stored in the pocket on the back of the front seat. 

Put the seat belt around the child's waist, and 

buckle to the crotch strap (Fig. 29). Adjust the seat 

belt to be snug around the child's waist. 

STAND ON THE PLATFORM

Position the child on the platform on the back 

of the stroller. Be sure child is standing facing 

foward and hands are holding frame. Secure the 

stand feature safety belt behind child and engate 

buckle (Fig. 30). Be sure that the child's feet are 

fully on the platform at all times.

SAFETY

9

10

CAUTION:

 Read the 

following section completely before 

folding your stroller!

WARNING:

  Care must be 

taken when folding and unfolding 

the stroller to prevent finger 

entrapment.

 

TO FOLD STROLLER

• Close the canopy as described in the canopy 

section. 

• Pull stroller backward several inches to rotate 

the front wheels to the front. (Fig. 31)

• To fold the stroller slide the      

RED

 thumb 

trigger to the left and squeezing the      

RED

 

pull trigger while pushing forward on the 

handle. (Fig. 32)  

• Once the stroller begins to fold, release the 

red handle and push forward on the handle 

until the stroller is folded.  Lock the release 

lever and the stroller wil stand freely in the 

folded postion. (Fig. 33)

SEAT PAD 

To clean the seat pad, use only mild household 

soap or detergent and warm water on a sponge or 

clean cloth.

OTHER 

Check your stroller for loose screws, worn parts, 

torn material or stitching on a regular basis.  

Replace or repair parts as needed. 

FOLD

Fig. 27

Fig. 28

Fig. 30

Fig. 29

Fig. 31

Fig. 32

Fig. 33

1

2

1

2

Summary of Contents for Sit N Stand D X







Reviews: