Young children may be injured by tipping furniture and the use of a tipping restraint is highly recommended.
When properly installed, this restraint could provide protection against the unexpected tipping of furniture due to
small tremors, bumps or climbing. We recommend mounting this restraint to a wall stud.
WARNING
:
This product is only a deterrent. It is not a substitute for proper adult supervision.
PART LIST
A [4] PLASTIC BRACKET
B [2] RESTRAINT STRAP
C [4] PHILLIPS SCREWS M4 x 30mm
D [4] PHILLIPS SCREWS M4 x 20mm
E [4] PLASTIC ANCHOR
INSTALLATION INSTRUCTIONS
1.
Attach two of the mounting brackets near the top
back edge of the furniture piece by inserting the
shorter screw.
2.
Determine the final position of the furniture piece.
Mark locations on the wall approximately 2"
below the brackets mounted to the back of the
furniture.
3.
Drill a shorter hole into the wall stud. If wall stud is
not available, drill a hole into the wall and insert
plastic anchor. Gently tap the anchor until the
flange is flush with the wall.
4.
Attach the second set of brackets by inserting the
longer screw through the bracket and into the
wall.
5.
Place the furniture so that the brackets on the
back edge are in line with the brackets in the wall.
6.
Lace one end of the nylon restraint strap down
through each bracket. Bring both ends together
and slide the beaded end until it snap locks into
the keyhole slot.
7.
To double lock; return the beaded end back
through the keyholes as shown.
8.
Check to make sure the straps are securely laced
and locked to the brackets
CARE INSTRUCTIONS:
•
Dust often using a clean, soft, dry lint-free cloth.
•
Blot spills immediately and wipe with a clean,
damp, cloth.
•
We do not recommend the use of chemical
cleansers, abrasives, or furniture polish on our
lacquered finish.
FURNITURE TIPPING RESTRAINT INSTRUCTIONS
Thank you for your purchase
www.restorationhardware.com
Page 3 of 3
