5
Cleaning
Remove driveshaft from bowl before cleaning in
dishwasher. See illustration.
To remove Driveshaft, turn Knob on bottom
of bowl clockwise and pull out. Rinse driveshaft
with water and wipe clean. Do not misplace Drivesh-
aft Gasket while cleaning. To replace the Driveshaft
after cleaning, insert into hole in bottom of bowl and turn
counter-clockwise to lock in place *.
Removing & Replacing the Driveshaft
6
Troubleshooting
Condition
Possible Cause
Possible Remedy
Machine will
not start.
Machine
stops during
operation
Final puree
consistency
isn’t smooth
Can not remove
Blade from
Driveshaft
Scaling in
Steam Tank
Blade is in dropped position
with driveshaft pins locked
in place.
Raw food isn’t diced finely
enough before steaming.
Low water content of raw
food.
Mineral rich water used
persistently.
Clean Steam Tank by wiping
with a damp scouring pad.
Lock bowl back onto machine.
Pull up on center while twisting
clockwise. Do not touch blades.
Water /Steam Tank is dry.
(Machine will beep rapidly
5 times to indicate that the
Steam Tank is Dry)
Steam Tank is dry.
(Baby Brezza will beep rapidly
5 times to indicate that the
Steam Tank is Dry)
Machine is unplugged.
Plug in Machine.
Safety tab on Bowl Lid is
not fully inserted into Base.
Safety tab on Bowl Lid has
been disengaged from Base.
Make sure Bowl Lid is turned
clockwise as far as possible
and safety tab on Bowl Lid is
fully inserted into Base.
Make sure Bowl Lid is turned
clockwise as far as possible
and safety tab on Bowl
Lid is fully inserted into Base.
Add water to Water Tank.
Add water to Water Tank.
Dice food into smaller pieces,
approximately 1/4”, before
placing in bowl.
Add additional water, formula,
breast milk or other liquid after
steaming and blend longer.
If you can not remedy problems with the machine by using the troubleshooting chart
above, please contact Customer Service at 1-888-396-6552.
Driveshaft
Knob
Always make sure Blade is in the up position when steaming.
1
2
Important Tips for Use
Up position for steaming.
Place the Blade on the
Driveshaft without turning it.
Down position for blending.
The blade will automatically drop
to the down position when blending.
The blade has two positions:
Up
Down
Always unplug the appliance before cleaning.
Clean the appliance before and after use.
Bowl, Blade and Bowl Lid are top shelf dishwasher safe and can also be hand washed.
To clean Water tank, fill with warm soapy water, tighten cap and shake vigorously.
Empty soapy water and rinse thoroughly before next use.
To Clean the Steam Tank, remove Steam tank lid and wipe with a damp scouring pad.
Base should be wiped with damp cloth only.
Never use abrasive pads to clean machine parts. (Except for stainless steel heating plate).
Never put the Driveshaft in the dishwasher. Wipe with damp cloth only.
Cut ingredients to approximately 1/4 to 1/2 inch pieces before placing in bowl.
Smaller pieces of food steam and blend more thoroughly, ensuring proper food texture
for your baby to easily swallow and digest.
*Always make sure Driveshaft & Driveshaft Gasket are
properly inserted and locked into place to prevent damage to bowl and base.
