4
1. The marked electrical rating of the detachable power-supply cord or extension cord
should be at least as great as the electrical rating of the appliance, and;
2. The longer cord should be arranged so that it will not drape over the countertop or
tabletop where it can be pulled on by children or tripped over unintentionally.
LINE CORD SAFETY TIPS
1. Never pull or yank on cord or the appliance.
2.
To insert plug, grasp it firmly and guide it into outlet.
3. To disconnect appliance, grasp plug and remove it from outlet.
4.
Before each use, inspect the line cord for cuts and/or abrasion marks. If any are found,
this indicates that the appliance should be serviced and the line cord replaced.
5. Never wrap the cord tightly around the appliance, as this could place undue stress on the
cord where it enters the appliance and cause it to fray and break.
DO NOT OPERATE APPLIANCE IF THE LINE CORD SHOWS ANY DAMAGE, OR IF
APPLIANCE WORKS INTERMITTENTLY OR STOPS WORKING ENTIRELY.
IMPORTANT
During the first few minutes of initial use, you may notice smoke and/or a slight odor. This is
normal and should quickly disappear. It will not recur after appliance has been used a few
more times.
BEFORE USING
Solid surface countertops can be easily scratched, cracked, scorched, or damaged, especially
when exposed to heat. To prevent damage, the following precautions should be observed
when using this product:
•
Always use a trivet under heat generating sources such as Slow Cookers, Toaster Ovens,
Skillets, or any kitchen appliance.
Carefully unpack the brownie maker and all parts. Remove all packaging materials, including
any stickers or labels.
Clean the interior and exterior surfaces of the brownie maker with
a damp cloth or sponge. Wipe dry with a soft cloth.
NEVER IMMERSE THE BROWNIE
MAKER OR CORD IN WATER OR ANY OTHER LIQUID.
Position the brownie maker on a
dry, level, heat-resistant surface. It is recommended to operate this appliance on a separate
outlet and circuit from other appliances to avoid overloading the circuit.
HOW TO USE
1. Position the brownie maker on a dry, level, heat-resistant surface.
2. Release the lid latch and lift the lid to the open position.
3. To maintain the quality of the nonstick it is recommended to periodically coat the nonstick
surface with a small amount of vegetable oil. This can be done with a paper towel or with
a nonstick oil spray. Wipe off any excess oil.
4. Plug the power cord into a 120V outlet, preferably on a separate outlet from other
appliances to prevent the circuit from being overloaded.
5. Lower the lid to the closed position and allow the brownie maker to preheat for a minimum
of 3 minutes. The red POWER light will be illuminated.
TIP: Prepare ingredients while the brownie maker is preheating.
6. When the brownie maker has preheated to the proper cooking temperature, the red light
