4
x4
x4
15
16
15
11
11
11
11
15
15
(M5X45)
(M6X30)
(M6X50)
16
4
16
16
16
16
10
9
15
Structure and instructions
1.
Check if all parts are included as listed.
2.
Insert the transverse nut bolt (11) into the holes provided in the wooden struts (4).
Make sure that the slots of the transverse nut bolt points upwards. Fix with the
screwdriver and hold tight.
3.
Connect the wooden struts (4) and the left base (1) by inserting a long metal
screw (9) through the lower opening of the base (1) and tightening with the Allen
key (12).
4.
Proceed with fixing the right foot (2) as well.
5.
Connect the metal rod (3) and the left base (1) by inserting a short metal screw
(10) through the center hole of the base and tightening with the Allen key (12).
Do not yet attach the metal bar (3) to the right foot (2).
6. Place the backrests (5)+(14) with the back side up on the flat and clean floor.
Insert the remaining two transverse nut bolt (11) into the slots provided on the
Backrest. Make sure that the slots of the transverse nut bolt (11) are pointing
upwards.
7.
Connect the Backrests (5)+(14) and the Left Stand (1) by inserting a long metal
screw (9) through the upper opening of the base and tightening with the Allen
key (12). Do not yet attach the backrest to the right foot (2).
8. Insert the safety bar (8) between the two feet (1)+(2). If necessary, pull the right
foot (2) aside. ATTENTION: The wooden dowels at
the two ends of the safety bar
(8) must be inserted in the holes provided in the insides of the feet. Already here
pull the crotch strap through the opening of the seat plate (6) and into the slots
provided on the backrest (14).
9.
Now connect the backrest (5)+(14) and the right foot (2), by inserting a long
metal screw (9) through the upper opening of the base and tighten with the Allen
key (12). The safety bar now sits firmly between both feet.
10. Insert the seat plate (6) at the desired height into the notches / groove. Insert
the foot plate (7) at a suitable height. Pay attention to horizontal seat of both
plates! Tighten all screw connections.
11.
If the height of the seat and foot plates is to be adjusted so that the chair adapts
to the size of the child, it is sufficient to loosen the strap and loosen the upper
and middle screws of one side to insert the plates like
described in the desired
height. Then tighten the screws again.
8
Family XL Highchair
