BaByliss for MEN POWERGLIDE TITANIUM 7448TU, Instruction Book

CLEANING & MAINTENANCE

For easy cleaning, the blades on your BaByliss For Men clipper are

removable. Regular cleaning will maintain their high performance level.

To clean proceed as follows:

• Switch the appliance off and unplug at the mains supply.
•  Remove any comb guides. Rinse the comb guide under running 

water and dry thoroughly before storage or use.

•  Remove the blades carefully noting which way round they are fitted. 

This will help with re-assembling.

•  Remove the two screws from the large fixed blade and detach this 

blade.

•  Now brush away the hair and other debris from the interior of the 

cutting head and blades.

•  Re-assembly is simply the reverse of the above instructions.
•  Finally, before fully tightening the two screws in the large blade, to 

avoid injury ensure that the blades are correctly aligned. With the 

taper control lever fully forward, the tips of the small blade must be 

parallel with and 1mm below the tips of the large blade. Also check 

that the extreme left hand tooth of the small blade is inside the large 

blade. (Failure to do so could cause injury).

•  Carefully tighten the two screws in the big blade, taking care not to 

disturb the above correct position of the blades.

NOTE:

 Do not attempt to repair or replace the blades. In the event that

the blades become blunt or damaged, contact the Conair Customer

Care Line (refer to UK «After Sales Service» section for further 

information).

INSTRUCTIONS FOR USE:
Preparation for Use

•  Always inspect the appliance before use for noticeable signs of 

damage. Do not use if damaged.

•  Ensure the trimming heads are free from hair and debris (refer to 

Cleaning and Maintenance section for further information).