INSTRUCTIONS FOR USE
• Ensure the hair is dry and combed through to remove any tangles.
• Start by dividing the hair into sections.
• To turn the appliance on, slide the switch to the heat setting suitable
for the hair type.
• Place the hot brush underneath the hair section close to the scalp
and hold for a few seconds to boost volume at the roots.
• Gently glide the hot brush through the hair section and start to
rotate the brush away from your head by pressing and holding the
appropriate rotation button.
• As you reach the ends of the hair section, continue rotating the brush
to roll the ends under.
• Repeat as necessary.
• After use, switch off and unplug the appliance.
• Allow to cool before storing away.
Heat Settings
If you have delicate, fine or coloured hair, use the lower heat settings.
For thicker hair, use the higher heat settings.
It is suggested to always complete a test on initial use to ensure the
correct temperature is used on the hair type. Start on the lowest
setting and increase the temperature until desired result is achieved.
Below is a guide of the temperature settings:-
0 = OFF
I = 160°C (Yellow)
II = 180°C (Orange)
III = 200°C (Red)
Rotation Settings
To make the brush head rotate, press and hold the buttons marked
<< and >>, this will make the brush head rotate clockwise and anti-
clockwise.
